Genelec 1238 DFM - active 3-way studio monitor, tri-amplified with DSP and magnetic shielding, ideal for recording and mastering studios, offers Direct Control Waveguide technology for excellent stereo audio imaging and balanced Off and On Axis frequencies. It provides tri-amplified power distribution, active DSP circuits, control via GLM software, and versatile crossover control. Ideal for use alongside Genelec monitors from the 8200/7200 series.
Technical specifications:
Low-pass filter: -3 dB: < / - 55Hz
High-pass filter: -3 dB: > / - 20kHz
Frequency response: 57Hz - 20kHz (± 2.0dB)
SPL:
Maximum short term sine wave acoustic output on axis in half space, averaged from 100Hz to 3kHz: @ 1m > 117 dB SPL
Maximum long-term RMS: at 1m > 107dB SPL
Maximum SPL per pair in listening room with audio material at 2 m: > 124dB
Self-noise level in half space at 1 m on axis (A-weighted): < / - 15dB
Harmonic distortion at 90dB SPL at 1m on axis
Frequency:
60 - 100Hz > 100Hz
< 1 %
< 0.5 %
Low-frequency drivers: 8" (210mm) x2
Mid-frequency driver: 5" (125mm) x1
High-frequency: 1" (25mm) metal dome x1
All drivers are magnetically shielded
Amplification:
Short-term low-frequency amplifier power: 150W at 4 Ohms
Short-term mid-frequency amplifier power: 120W at 8 Ohms
Short-term high-frequency amplifier power: 120W at 8 Ohms
Long-term amplification is limited by protection circuits.
THD at nominal output: < 0.05 %
Signal-to-noise ratio:
Bass: >/- 100dB
Mid: >/- 100dB
High: >/- 100dB
Power supply: 100/200 or 115/230V
Power consumption:
Idle: 23VA
Full Output: 330VA
Digital signal input connectors: XLR female 110k Ohm, AES/EBU Single Wire or Dual Wire
Digital signal output / Thru connector: XLR male 110k Ohm, AES/EBU Single Wire or Dual Wire
Analog signal input connector: XLR female, balanced 10k Ohm, pin 1 gnd, pin 2 +, pin 3 -
Word length: 16 - 24 Bits
Sample rate: 32 - 192kHz
Control interface: Proprietary GLM network
Connection: 2x RJ45 cables, CAT5
System calibration: AutoCal, GLM manual, Stand-alone
