Solvent-based adhesive made from SBS rubber, with the addition of synthetic resin and modifying agents.
APPLICATION:
Designed for the furniture industry for bonding: polyurethane foam, polyester foam, satin fabric, felt, jute, upholstery rubber, carpets and other upholstery materials on metal, concrete, raw wood and varnished wood, as well as wood-based materials. It is also used for bonding polystyrene.
To achieve the strongest effect, we recommend applying the adhesive surfaces as follows: on a wall, apply horizontal stripes and on the panel, apply vertical stripes. This technique activates the adhesive cells and allows for a very strong bond.
FEATURES:
dries quickly;
has a short open time;
does not chemically interact with the bonding surfaces;
easy to use;
capacity of 500 ml.
APPLICATION METHODS
Prepare the surface, ensuring that both surfaces are clean, dry, free of dust, dirt and grease. If necessary, rinse the surface with the recommended solvent-based cleaning agent, but wait until the solvent evaporates. DO NOT USE SPIRIT, DENATURED ETHYL ALCOHOL OR CITRUS. Do not touch the cleaned surfaces.
Apply a uniform and thin layer of adhesive. The adhesive should be applied from a distance of 10-25 cm from the surface, so that the layers overlap by 50-70%, reducing the risk of excess adhesive on the bonded surfaces (note - ensure that the appropriate layer has been applied).
It is necessary to maintain a constant speed when applying the adhesive, so that excess adhesive does not accumulate in certain areas on the surface. To achieve a good bond, approximately 80-100% of the surface must be covered (approx 20 g/m²).
It is recommended to use one tube for approximately 10 - 15 square meters.
The best adhesion is obtained when the surfaces are joined at a 90° angle to each other. It is recommended to double the applied layer on the edges of the surface.
ADHESIVE USAGE MANUAL:
Application temperature (including adhesive temperature, bonded elements, environment): 18°-25° C;
The bonded surfaces must be dry and clean beforehand;
The container must be shaken well before spraying;
Apply the adhesive evenly on the surface of both elements to be bonded, wait at least 2 minutes (for solvent evaporation) and then combine the elements together before the adhesive hardens (15 minutes) and then press them well;
Once the elements have been bonded, it will no longer be possible to make corrections. Do not expose the bonded materials to high temperatures before reaching the maximum adhesive strength.
The adhesive reaches maximum strength after 48 hours.
