Very good, a bit narrow for the Hyper X Solocast, but it fits, you have to press a little harder and it stays without problems.
Solid construction and works with Adam Hall TBA 01 (desk) microphone arm.
Fits on microphones with a diameter larger than 49cm, I personally use it for HyperX Solocast. I replaced the original 5/8'' mount with a 3/8'' one for my arm without any issues. I recommend it!
I give it a 4 out of 5 for how the product was packaged. The bag in the box was open and the thread at the top of the shock mount was undone. Basically, the whole system was only held by the thread at the bottom, with the support where the microphone goes being tilted a few degrees, quite enough. I had to grab a small pliers and fix it in the metal clamp and put it back in place.
I haven't mounted it on the microphone yet since I only get home tonight.
But I was disappointed with this situation, I hope that clamp holds, as it seems a bit fragile.
After using a studio microphone directly on the stand and then the same microphone with this shockmount, you'll notice, just like I did, that there's a big difference in recording! ... so ... I won't say more than, get this shockmount!
