Designed, built and tested in Nashville, Tennessee.
True Bypass Switching. The devices use standard mechanical true-bypass switching. Audio will passthrough if the switch is turned off, and/or if there is no power to the pedal.
Switchcraft jacks
9V only. External power supply required. Power supply not included. There is no battery clip inside.
Current Draw: Less than 10 mA
Length x Width x Height (incl. sockets, knobs, etc.): 125 x 66.5 x 56.6 mm
“Daylight” is a symmetrical overdrive, on the brighter side (hence the name). It is a pleasantly dynamic, musical, and focused.We designed this pedal to work well with various guitar and amp combinations, using every combination we could think of... vintage, boutique, budget, etc. Then, we spent a year sharing the pedals with session players in Nashville. This is the final product, and we like it a lot!
The controls are simple, just three knobs. Start with each control at 12:00 (high noon), and then experiment. We worked hard to make sure the 12:00 setting was a good starting place out of the box.
Level: Level controls the volume of the output.
Tone: Tone controls the darkness/brightness of the tone.
Drive: Drive controls the amount of overdrive/distortion.
Specifications
Made in the USA.
Designed, built and tested in Nashville, Tennessee.
True Bypass Switching. The devices use standard mechanical true-bypass switching. Audio will passthrough if the switch is turned off, and/or if there is no power to the pedal.
Switchcraft jacks
9V only. External power supply required. Power supply not included. There is no battery clip inside.
Current Draw: Less than 10 mA
Length x Width x Height (incl. sockets, knobs, etc.): 125 x 66.5 x 56.6 mm
Note on power requirements This device can be safely powered with a standard external 9-Volt DC power supply with a 2.1mm center-negative barrel connector. External power supply required; power supply not included. There is no battery clip inside.
Please be advised that this device requires 9 Volt (9v) DC power only. Do not run at higher voltages. Do not power the device with AC power. Do not reverse polarity. If you are confused or unsure, stop and ask for assistance. We would be happy to help you. Using an incorrect power supply may damage the device and void your warranty. We want to make sure you don't fry your pedal and regret it.
***Check our DOWNLOADS section below for more info.***
